View single post by Russ Huber
 Posted: Fri Feb 26th, 2016 04:06 am
PMQuoteReplyFull Topic
Russ Huber



Joined: Mon Nov 14th, 2005
Location: Southwest, Wisconsin USA
Status: 
Offline
Kim Frank wrote: A piece of PVC machined to a couple thousandths over the stator diameter. Stick the motor housing against the edge of the PVC with the stator fitting inside, slap it on the concrete floor a couple of times and you have a removed stator. No bent or torqued housings....Mike Petree turned me on to this a few years back. I normally don't bother with pressed fit W/H motors but unfortunately, that is what is on the Gyros.......There is a lip that catches the stator and keeps it from falling thru the PVC.

Attached Image (viewed 1033 times):

IMG_1988.JPG