View single post by David Dimitrion
 Posted: Fri Feb 26th, 2016 04:18 am
PMQuoteReplyFull Topic
David Dimitrion

 

Joined: Wed Feb 18th, 2015
Location:  
Status: 
Offline
You need a  5"OD x 3 1/2 tall or so and a machined ID of 4.765 piece of pipe I think Kim Frank uses a piece of PVC I like steal...I have done at least couple dozen this way with out any damage to the housing or paint... I unscrew or remove the rivets holding the ID tag. no need to remove the isolator or bearing support and base mount... hold or tape the motor housing to pipe and Bang down on a piece of wood no heat needed... The stator comes right out. I sand the inside of the housing and the outside of the stator so it goes in a little easier hope this helps