View single post by David Hoatson
 Posted: Wed Sep 16th, 2020 01:30 am
PMQuoteReplyFull Topic
David Hoatson



Joined: Sat Oct 5th, 2013
Location: Chestertown, Maryland USA
Status: 
Offline
UPDATE:
The new batch of tools is done, ready to ship. PM me or email: info@ChestertownElectric.com



I made several stator removal tools for the common Westinghouse stamped steel fans. 4-3/4” stator outside diameter. Even fits Rotaire ceiling fans. 
Based of Tony Clayton’s design, the tool is a steel cylinder that is machined to mate with the motor case. By banging the tool and motor on a hard surface, the stator coil works its way out of the motor housing. 

I made three and sold one. I’m keeping one and selling my last one at cost: $145 shipped. 




Last edited on Thu Oct 8th, 2020 04:14 pm by David Hoatson