| |||||
AFCA Forums > Antique Fan Collectors Association > Buy-Sell-Trade > Nickel plate 1/25 HP Brushed Dumore Jewelers Lathe Motor FS |
Moderated by: Steve Cunningham, Stan Adams, Rod Rogers |
|
Nickel plate 1/25 HP Brushed Dumore Jewelers Lathe Motor FS | Rate Topic |
Author | Post |
---|
Posted: Mon Nov 15th, 2021 04:52 am |
|
1st Post |
Russ Huber AFCA Member ![]()
![]() |
Runs great, looks great, has a black knob motor reversing feature on the back. Facing the back of the motor if you turn it to the left it spins clockwise, turn it to the right CCW. Center the knob and the motor stops. The armature shaft is 1/4" and will take a brass GE 8" or 9" blades of past. $80.00 + shipping. You will need to attach a new power cord of your choice and plug. There is a decent condition cord leading off the motor 14" long I used to test it.![]() ![]() ![]() ![]() ![]() ![]() Last edited on Wed Nov 17th, 2021 05:52 pm by Russ Huber |
|||||||
|
Posted: Mon Nov 15th, 2021 05:18 am |
|
2nd Post |
Russ Huber AFCA Member ![]()
![]() |
The motor can be removed from the base, it is held in place with 2 screws.
|
|||||||
|
Posted: Mon Nov 15th, 2021 06:02 pm |
|
3rd Post |
Thomas Peters AFCA Member
![]() |
Like you state, this motor with pulley, was used with a lathe. Looks like the one in the ad. Last edited on Mon Nov 15th, 2021 06:05 pm by Thomas Peters |
|||||||
|
Posted: Thu Nov 18th, 2021 12:00 am |
|
4th Post |
Russ Huber AFCA Member ![]()
![]() |
Price reduced. It is a very nice example both from a mechanical and cosmetic standpoint. I put the motor up on a platform and put a 9" Whiz blade on it. It spun the blade just like downtown. ![]() Last edited on Thu Nov 18th, 2021 12:03 am by Russ Huber |
|||||||
|
Posted: Sat Nov 20th, 2021 04:52 pm |
|
5th Post |
Russ Huber AFCA Member ![]()
![]() |
A little imagination can go a long ways. The motor does not have the typical loud whining brush motor noise. The oil ports can be drilled and tap threaded for oil cups. The motor could be mounted upside down in a cabinet. Motor speed can be controlled with a rheostat. ![]() ![]() ![]()
|
|||||||
|
Current time is 10:39 pm | |
AFCA Forums > Antique Fan Collectors Association > Buy-Sell-Trade > Nickel plate 1/25 HP Brushed Dumore Jewelers Lathe Motor FS | Top |