View single post by Dustin Meyer

Posted: Wed Feb 27th, 2013 05:23 pm

Joined:	Tue Feb 7th, 2012
Location:	Tulsa, Oklahoma USA
Status:	Offline

I've seen the steel drive pins on McMaster Carr but I'm looking for brass. I need them for fastening the data plate on a coin op where there are blind holes. I can buck soild rivets where there is a thru hole. These are not escutcheon pins which are basically finish nails. I know they exist or at least used to because I have removed them from data and switch plates in the past.