View single post by Louis Luu

Posted: Sun Jun 13th, 2021 11:04 pm

Joined:	Sat Oct 2nd, 2010
Location:
Status:	Offline

All cleaned. I decided to try and polish one. You will need to run the back with a belt sander to level it. I made sure there was plenty of metal in the back for this purpose.

Note the metal will yellow with time. The first two was taken outside in the sun and the last picture inside.

The screw used on the ECK is 8-32

Please do NOT use a wire wheel to polish the badge. I used a dremel polishing wheeel with red rouge and wiped off with a cloth.